According to the current development trend of pipe welding equipment, how to better use the pipe welding equipment is particularly important. Today, we mainly talk about the following points
1. Do not touch the mold during operation.
2. Before using welded pipe equipment, we should first check whether all lubricating points on the unit are fully lubricated.
3. Do a good job of daily maintenance, so that the service life will be long.
No matter the parts or the whole machine, the rust prevention of the welded pipe unit shall be well done. First, try to avoid placing pipe welding equipment in damp places. In addition, it is rust removal grease. In addition to rust prevention, we must also strictly carry out maintenance work.
The operation of pipe welding unit equipment shall strictly follow the normal operation process. Before starting the machine, lubricate the machine regularly, regularly and quantitatively according to the lubrication chart. The lubricating oil must be clean and free of impurities.
The welding pipe unit shall regularly replace the lubricating oil in the bearing, regularly check the electrical appliances, and eliminate the unreliable safety factors. The V-belt, handle, knob and key of the pipe welding machine shall be inspected regularly for damage.
The specific butt welding process is as follows:
1. After the coil is positioned, the left and right cones of the uncoiler can be inserted into the coil and rotated at the same time. Send the wire to the pinch roll, press down the upper roll of the pinch roll, and the coil car and magnetic roll can return to their original positions.
2. In order to make the spring steel strip run accurately in the center, the uncoiler can move+150 mm axially as a whole before running. After the uncoiler is started, the strip steel reaches the straightener with dust removal device through the pinch roll.
3. Use the sliding hydraulic shear to shear the straightened spring steel strip at the head and tail of the strip steel (the sheared strip steel head can slide into the waste bin immediately, and the sheared strip steel tail can be collected into the special aggregate bin outside the production line through the output device).
