Methods to Improve The Efficiency of Slitter
The aligning stop arm and support arm on the slitting machine equipment can also be used for trimming and straightening. The plate used as the front stop and the long support is all its contribution to the positive stop arm. However, the support arm is mainly used to support the raw materials at the front of the slitter. It is worth mentioning that the equipment can also accurately measure the effectiveness of the cut parts together with the appropriate front stopper.
In addition to the support effect on the positive stop arm and support arm, the plate support equipment on the slitting machine must be able to play the same role immediately and fully. But at the moment, we should also pay attention to that the equipment is installed behind the cutter head, so that the raw materials can resist the back stop and support the raw materials, so as to avoid the looseness of the raw materials and ensure the accurate wound site.
At the air intake system level. There will also be a manual centralized air intake system in the slitting machine equipment, as well as a fully automatic air intake system. At this moment, several moistening points will be properly moistened at the same position, and the excellent moistening level will promote the smooth application of the equipment.
In the future, the key point will be the adjustment of the gap between the wounds on the slitting machine, which itself will be divided into manual and full-automatic. Naturally, no matter which one is used, the back of the wound gap can be better adjusted to match the thickness, specification and type of the raw materials to be cut, so as to improve the actual cutting effect.
